Batch Warning Sign

Hey All,

Sure this is probably something stupid and obvious that I’m overlooking, but I’ve gotten into some sort of state where my Batch Schematic has a warning sign in the lower right corner and when I do certain things - like moving an axis in Action, it does not update my Broadcast monitor without me stepping forward or backwards a frame.

I feel like I’ve checked all Degradations and they are all turned off. Anyone know what’s going on?

Update under view is set to All Viewports…

Check your stone and wire and see if you’ve had a disk failure.

Thanks for the suggestion… but it was only happening in a particular Batch setup. Other setups were fine as far as I could tell. Perhaps something just got weird.

I would check anyway. The other batch setups may not have had any media on the bad drive.

According to zpool all drives are good. :crossed_fingers:

1 Like