FLAME 2025 Rocky Linux 9.5 DKU file where to download?

Flame Hardware Questions
1

Just installed Rocky Linux 9.4 , the DKU download link is for 9.3 . Where can I get the DKU for 9.4. Flame 2025 trouble installing on 9.4.

2

You are clearly not using the ADSK RL9.3 iso. You should only use ADSK install iso.

1 Like
3

Installation for individuals

4

yes, thank You for the quick reply . Flame system requirements page states Linux 9.5 is min requirement, so that’s why I installed 9.5, but apparently only 9.3 works with flame 2025

1 Like
5

Hey Rohan, welcome to the community. Where are you seeing that Rocky 9.5 is required?

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/flame-2025-sysreqs.html

And download from here….

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/CentOS-ISO-installer-and-Linux-Driver-Kernel-Utilities-for-Flame-Family.html

1 Like
6

Hi Randy, I installed Rocky Linux 8.7 and DKU 19.0. (I tired 9.3 as well earlier)
Cannot boot after installing DKU. Bios is on Unsecure boot.
My GPU is A4000, AMD 5950x

7

Assuming that it just hangs during boot, you can get around that by editing the Grub parameters so that you can check logs and debug further.

See here: Rocky Road 9.3 - #27 by allklier

1 Like
8

Linux 9.3 installed , DKU 19.0.0 installed. (because im using Nvidia A4000 GPU)
Flame 2025 downloaded , but installation is unsuccessful , Error 1.

9

I would follow the guidance above regarding system requirements as well as following the Linux Setup guide.

You may also want to have a peek at your BIOS settings to account for the unsecured boot.