Questions about the GmaskTracer Node in Flame 2025.1

Flame Flame Questions
1

Hello, I am not good at English.
I used a translator to write this article… Please understand even if the sentences are a bit unnatural~
I have a question about using the Gmask Tracer node in Flame 2025.1 version.(Linux_Rocky8.5)
When creating a Gmask, the positions of the cursor and the mask point do not match, and the mask point is created at a certain distance (see Photo-1).

Photo-01
Photo-011920×2560 859 KB

Also, when selecting a point to modify after creating a mask, you need to click at a location that is a certain distance from the point to select the mask point. (see Photo-2)

Photo-2
Photo-21920×2560 642 KB

In version 2024, the mask point and the cursor were always created and selected at the same location. Did this change in version 2025? Or is it a bug?

2

Mac or Linux? Local or remote? I’ve seen this using remote access on Mac before.

3

It’s Linux(Local/Rocky8.5). Mac was fine.
Could it be because the DKU version is not correct?
The current DKU version is 18.2.0 (Flame2024.2)

4

Also check the tablet driver.